| Product Name | PolyLite PC |
|---|---|
| Product Use | 3D Printing Filament |
| Manufacturer/Supplier | JF Polymers (Suzhou) Co., Ltd. |
| Address | 2901 Auburn Rd, Auburn Hills, MI 48326 |
| Contact Email | info@rev1tech.com |
| Telephone | +248-707-2950 |
| Emergency Telephone Number | +248-707-2950 |
PolyLite™ PC is produced using a polycarbonate resin specifically engineered for 3D printing. It delivers good stiffness and heat resistance with light diffusing properties.
| Property | Test Method | Value |
|---|---|---|
| Density | ISO1183, GB/T1033 | 1.19 g/cm3 at 23°C |
| Melt index | 260°C, 2.16kg | 8-11 g/10min |
| Light transmission | GB/T 2410 | 89% |
| Flame retardancy | N/A | N/A |
| Effect of weak acids | Slight resistant | |
| Effect of strong acids | Not resistant | |
| Effect of weak alkalis | Slight resistant | |
| Effect of strong alkalis | Not resistant | |
| Effect of organic solvent | Not resistant | |
| Effect of oils and grease | No data available | |
| Equilibrium water absorption (%) | 0.253% |
| Property | Test Method | Value |
|---|---|---|
| Glass transition temperature | DSC, 10°C/min | 113.4 °C |
| Decomposition temperature | TGA, 20°C/min | ＞360°C |
| Vicat softening temperature | ISO 306, GB/T 1633 | 119.5 °C |
| Heat deflection temperature (1.8MPa) | ISO 75 | 106.6 °C |
| Heat deflection temperature (0.45MPa) | ISO 75 | 111.2 °C |
| Property | Test Method | Value (X-Y) | Value (Z) |
|---|---|---|---|
| Young’s modulus | ISO 527, GB/T 1040 | 2307 ± 60 MPa | 2260 ± 137 MPa |
| Tensile strength | ISO 527, GB/T 1040 | 62.7 ± 1.3 MPa | 41.9 ± 2.1 MPa |
| Elongation at break | ISO 527, GB/T 1040 | 3.15 ± 0.35 % | 2.2 ± 0.2 % |
| Bending modulus | ISO 178, GB/T 9341 | 2247 ± 159 MPa | N/A |
| Bending strength | ISO 178, GB/T 9341 | 100.4 ± 2.1 MPa | N/A |
| Charpy impact strength | ISO 179, GB/T 1043 | 3.41 ± 0.03 kJ/m2 | N/A |
* Based on 0.4 mm nozzle and Simplify 3D v.4.0. Printing conditions may vary with different nozzle diameters.
The typical values presented in this data sheet are intended for reference and comparison purposes only. They should not be used for design specifications or quality control purposes. Actual values may vary significantly with printing conditions. End-use performance of printed parts depends not only on materials but also on part design, environmental conditions, printing conditions, etc. Product specifications are subject to change without notice.
Each user is responsible for determining the safety, lawfulness, technical suitability, and disposal/recycling practices of materials for the intended application. Rev1Tech makes no warranty of any kind, unless announced separately, to the fitness for any use or application. Rev1Tech shall not be made liable for any damage, injury, or loss induced from the use of Rev1Tech materials in any application.
Click here to shop PolyLitePC.