SAFETY DATA SHEET

1. PRODUCT AND SUPPLIER INFORMATION

Product Name: CarbonX ezPC+CF

Chemical Name: Polycarbonate (PC)

Recommended Use: Additive manufacturing

Supplier Information:

• Rev1Tech
• 904 36th Street, Suite B
• Grand Rapids, MI 49500
• Phone: +248-707-2950
• Email: info@rev1tech.com

2. HAZARDS IDENTIFICATION

Regulation (EC) NO 1272/2008: Not classified as a dangerous product

Physical Hazards: None

OSHA Regulatory Status: This product is not considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)

3. COMPOSITION/INFORMATION ON INGREDIENTS

4. EMERGENCY FIRST AID

• Eyes: Flush with water. Consult physician if symptoms persist.
• Skin Contact: Wash with soap and water. For thermal burns from molten polymer, immediately flush with cold water. Do not attempt to remove cooled polymer from skin. Obtain medical attention.
• Inhalation: Leave exposed area and seek fresh air. If irritation persists seek medical attention.
• Ingestion: Not likely due to nature of product. If ingested, drink plenty of water. Do not induce vomiting. Consult a physician if symptoms persist.

5. FIRE AND EXPLOSION HAZARD

• Extinguishing Media: Water spray, dry powder, and foam. Carbon dioxide (CO2)
• Safety Precautions: Persons exposed to products of combustion should wear NIOSH approved self-contained breathing apparatus and full protective equipment.

16. MISCELLANEOUS INFORMATION

Prepared by: Business Management

Issued: 08/01/2022

This information set forth herein has been gathered from standard reference materials and/or supplier test data and is, to the best knowledge and belief of Rev1Tech, accurate and reliable. Such information is offered solely for your consideration, investigation and verification, and it is not suggested or guaranteed that the hazard precautions or procedures mentioned are the only ones which exist. Rev1Tech makes no warranties, expressed or implied, with respect to the use of such information or the use of the specific material identified herein in combination with any other material or process, and assumes no responsibility therefore.

Click here to shop CarbonX ezPC+CF.

END OF SDS