Obsidian GF15 Nylon V1 Technical Data Sheet | Rev1Tech

Technical Data Sheet: Obsidian™ GF 15% Glass Fiber PA6 3D Printing Filament


Obsidian GF15 Nylon V1 Technical Data Sheet

Physical Properties

PropertyStandardUnitTypical Value
DensityISO 1183g/cc1.22

Mechanical Properties

PropertyStandardUnitTypical Value
Tensile Strength, BreakISO 527MPa85
Tensile ModulusISO 527GPa4.6
Tensile Elongation, BreakISO 527%5.8
Flexural Strength, YieldISO 178MPa128
Flexural ModulusISO 178GPa4.7

Thermal Properties

PropertyStandardUnitTypical Value
Glass Transition Temperature (Tg)DSC°C70
Deflection Temperature at 0.45 MPa (66psi)ISO 75°C176

Electrical Property

PropertyStandardUnitTypical Value
Surface ResistanceASTM D257Ohm/sq>109

www.rev1tech.com

Specimen Orientation

XY Flat

Printed Specimen Conditions

Printer: Markforged Onyx One™

Layer Height: 0.125mm

Infill: 100%

Disclaimer: The technical data contained on this data sheet is furnished without charge or obligation and accepted at the recipient’s sole risk. This data should not be used to establish specifications limits or used alone as the basis of design. The data provided is not intended to substitute any testing that may be required to determine fitness for any specific use.

TDS Rev 1.0

PropertyStandardUnitTypical Value
DensityISO 1183g/cc1.22

Mechanical Properties

PropertyStandardUnitTypical Value
Tensile Strength, BreakISO 527MPa85
Tensile ModulusISO 527GPa4.6
Tensile Elongation, BreakISO 527%5.8
Flexural Strength, YieldISO 178MPa128
Flexural ModulusISO 178GPa4.7

Thermal Properties

PropertyStandardUnitTypical Value
Glass Transition Temperature (Tg)DSC°C70
Deflection Temperature at 0.45 MPa (66psi)ISO 75°C176

Electrical Property

PropertyStandardUnitTypical Value
Surface ResistanceASTM D257Ohm/sq>109

Specimen Orientation: XY Flat

Printed Specimen Conditions

Printer: Markforged Onyx One™

Layer Height: 0.125mm

Infill: 100%

TDS Rev 1.0

Disclaimer: The technical data contained on this data sheet is furnished without charge or obligation and accepted at the recipient’s sole risk. This data should not be used to establish specifications limits or used alone as the basis of design. The data provided is not intended to substitute any testing that may be required to determine fitness for any specific use.

For more information, visit rev1tech.com

Click here to shop this material.